KNX Programming by a Specialist Company
New project, extension or visualization: we program your KNX system in ETS and hand it over tested and documented. Over 20 years of experience in system integration.
What does KNX programming include?
KNX programming is the configuration of all devices in the ETS software. Physical addresses are assigned, parameters are set, and sensors and actuators are linked via group addresses. The configuration is then transferred to the devices.
New project
Lighting, climate, shading and security in one consistent programming. For residential and commercial buildings.
Extension and retrofit
Integrating new ABB or Zennio components into the existing system, without tearing anything out.
Visualization
Operation via touch panel or smartphone, developed to fit your system.
KNX system integrator for new builds and existing systems
As a KNX system integrator we handle planning, ETS programming, control cabinet building and commissioning from one source. You have one contact who knows the topology and stays available after handover. We also read out and take over existing systems from other integrators.
Can you program KNX yourself?
Yes, the basics can be learned with ETS. For larger systems, logic functions, visualization and commissioning, a specialist company pays off, because mistakes in the group address structure become expensive later.
- Plan the group address structure in advance instead of creating it on the side.
- Test every function before handover.
- Back up and document the finished ETS project.
What does KNX programming cost?
The effort depends on the number of devices, the required functions and the visualization. We do not quote a flat price, because without an overview of your system it would not be reliable. After a short conversation you will receive a concrete assessment.
Send us a floor plan or a photo of the distribution board on WhatsApp. That is enough to get started.
ETS file lost or system unstable?
That is what our KNX Help-Line is for. We read out the system, reconstruct the project and deliver a clean new ETS project.
Programming and control cabinet from one source
We build distribution boards in-house. Programming happens in parallel. You receive a pre-programmed and tested control cabinet directly on site. That saves commissioning time.
More: KNX control cabinet building and mistakes in distribution board construction. Before you start: KNX planning, KNX costs and KNX or Loxone.
Technically responsible: Alexander Zalesskiy, Senior KNX Consultant, with over 20 years of experience in building and automation technology.
Frequently asked questions about KNX programming
Can you program KNX yourself?
Yes, with the ETS software devices can be parameterized and linked via group addresses. For larger systems, logic functions, visualization and commissioning, a specialist company pays off.
What does KNX programming cost?
The effort depends on the number of devices, the required functions and the visualization. After an overview of your system you will receive a concrete assessment from us.
Which software is used for KNX programming?
The standard is ETS (Engineering Tool Software). Devices from different manufacturers are planned, parameterized and commissioned in it.
Do you also program visualizations?
Yes. We develop custom visualizations for operation via touch panel or smartphone.
Do you deliver the control cabinet pre-programmed?
Yes. We build the distribution boards ourselves and deliver them pre-programmed and tested to the construction site.
What if the ETS file is lost?
The system can usually be read out and reconstructed. Afterwards a working ETS project is available again.
Do you need your system programmed?
Call us or write on WhatsApp. We will get back to you with a first technical assessment.
AGR Technologies GmbH is a partner of:
